Building tools

 

 I've made a few useful tools for the latest build project. A couple of sanding blocks, 150X50mm, that I stuck 120 and 240 grit paper to, when they wear out you can prise off the paper and replace, or if that dose'nt work they only take about 30 minutes to print. I also made a sanding block that fits the servo cutout holes in the wing, it's 34mm at one end and 44mm at the other and 4mm thick. I also made some magnetic right angle jigs, the magnets were for another project but were not used, they are quite strong, so care is needed. They were made to fit between the wing ribs to hole them upright when glueing. 

I also made a box to hold round and flat scalpels, it's got a bit of foam in the bottom, which can be replaced, to protect the tips.  

Overall, I'm pleased with the Bambu P1S, I've had few print failure's and there has been a minimum of tweaking required to get good prints.